3D Printers

Forums

Hello!

What 3D printer do you recommend or have experience with at your library? I am looking to purchase one over the next few months!

If you like you can always email me too: klimek [at] cranburypubliclibrary.org

Thanks!

Dean 

We have had good luck with Makerbot.  We currently have a Replicator+ that is much more consistent in it's print than the Replicator 2X we first had (I will say the duel extruder was nice but much too large a fail rate).  I know there are less expensive products on the market but it is very reliable and the customer service has been good.  They also are not afraid to send out replacement parts/units if you have the maker care (again pricey).  Good luck and feel free to call if you have any further questions. 

 

Dave

973 729-3101